自慰流水喷白浆免费看

  • Welcome to the website of Jiangsu Hongda!

    phone:13862977663

    tel:0513-85390199

    Industry News

    Analysis of the cause of overheating of the plunger pump

    點擊:642 發布時間:2020-05-06

    The cause of the overheating of the plunger pump is more complicated, and the location of heat generation is not single, including liquid and mechanical aspects. There are many reasons for overheating in each part. The following plunger pump manufacturers will introduce the causes of overheating in liquid and machinery. There are two reasons for the excessive heating of the plunger pump, as follows:

    對柱塞泵過熱的原因進行分析
         One is the mechanical conflict heat
         Because the appearance of the movement is in a state of conflict or semi-interference, the moving parts conflict with each other to generate heat;
         The second is liquid conflict heat
         High-pressure oil leaks into the low-pressure chamber through various gaps, and a lot of hydraulic energy loss is converted into heat energy.
         Therefore, the accurate selection of the gap between the moving parts, the volume of the oil tank and the cooler can prevent the appearance of excessive heat generation and excessive oil temperature of the pump. In addition, the return oil filter becomes clogged and the back pressure of the return oil is too high, which can also cause excessive oil temperature and overheating of the pump body.
         The editor here should remind everyone that the cause of the overheating of the plunger pump, in addition to the above two aspects, also pay attention to the working environment of the plunger pump, the heat dissipation conditions are good or bad.

    相關標簽:
    新聞資訊
    相關產品
    自慰流水喷白浆免费看